Take complete control over your tone, EQ settings, and effects with the PZ-Pro, a two channel instrument preamp, DI and switcher. Each channel features a separate equalizer strip complete with a filter section to reduce feedback on stage. The second channel of the PZ-Pro also features a microphone input to allow any dynamic or condenser microphone to be used, including clip-on instrument mics. Three footswitches provide the ability to toggle between each input channel, activate a built-in booster and an effects loop, or mute the signal for silent tuning on stage.
Features:
2 channel acoustic instrument preamp with separate EQs
Piezo input boosters available on both channels
XLR input with available phantom power on channel 2
Assignable FX loop with wet/dry control
Specifications
Audio Circuit Type: Proprietary active circuit
Number of Channels: 2x Inputs, Mono Pre and Post EQ XLR balanced Out
Frequency Response: 20Hz–20kHz (+/-0.5dB)
Gain: +20dB (Instrument Input), +55dB (Mic Input)
Clip Level: +10dBu @ XLR output
Total Harmonic Distortion: <0.005% @ 1kHz
Input Impedance: 220k Ohm at input jack (10M Ohm with PZ Boost active)
Output Impedance: 1k Ohm
Noise: -91dB
Features
Functions: 180° polarity reverse, Ground lift, Effects Loop, EQ Control, Boost
Input Connectors: 1/4" Instrument, XLR Microphone
Output Connectors: Pre and Post EQ XLR, 1/4" Amp Out
Extras: 1/4" Effects Loop, Boost, Tuner
General
Construction: 14-gauge steel
Weight: 5.0 lbs (2.27 kg)
Dimensions (L x W x H): 9.10" x 5.32" x 1.82" (231 x 135 x 46 mm)
Power Supply: 15VDC 400mA, center-pin positive
Operating Conditions: For use in dry locations only, between 5°C and 40°C
Features:
2 channel acoustic instrument preamp with separate EQs
Piezo input boosters available on both channels
XLR input with available phantom power on channel 2
Assignable FX loop with wet/dry control
Specifications
Audio Circuit Type: Proprietary active circuit
Number of Channels: 2x Inputs, Mono Pre and Post EQ XLR balanced Out
Frequency Response: 20Hz–20kHz (+/-0.5dB)
Gain: +20dB (Instrument Input), +55dB (Mic Input)
Clip Level: +10dBu @ XLR output
Total Harmonic Distortion: <0.005% @ 1kHz
Input Impedance: 220k Ohm at input jack (10M Ohm with PZ Boost active)
Output Impedance: 1k Ohm
Noise: -91dB
Features
Functions: 180° polarity reverse, Ground lift, Effects Loop, EQ Control, Boost
Input Connectors: 1/4" Instrument, XLR Microphone
Output Connectors: Pre and Post EQ XLR, 1/4" Amp Out
Extras: 1/4" Effects Loop, Boost, Tuner
General
Construction: 14-gauge steel
Weight: 5.0 lbs (2.27 kg)
Dimensions (L x W x H): 9.10" x 5.32" x 1.82" (231 x 135 x 46 mm)
Power Supply: 15VDC 400mA, center-pin positive
Operating Conditions: For use in dry locations only, between 5°C and 40°C
